Industrial Edge IIH Essentials Databus Credentials Error

0
Question: I need help troubleshooting my Databus setup in IIH Essentials. I'm unable to connect because I can't locate the Edge Hub data bus configurator.Context: I previously installed Databus using a username and password that may not have been configured correctly. I have the following components installed: OPCUA Connector, Databus, IIH Essentials, and S7 Connector.Error Message: I'm receiving an error in IIH Essentials (error details to be shared below).What I need: Guidance on where the Edge Hub data bus configurator should be located and what steps I might have missed during the initial setup.
asked
2 answers
1

Hi Erdem Bayram


The Databus Configurator is not located in the Application Manager anymore, which is why you couldn’t find the “Edge Hub Databus Configurator.” In current Industrial Edge versions, you must open it from the Industrial Edge Management (IEM) interface. Switch to the new IEM UI, then go to Applications → Management Applications, where the Databus Configurator can be installed and launched.

Once inside the configurator, you must create the Databus user (username, password, topic permissions) and deploy the configuration. Those same credentials must then be entered inside IIH Essentials → Databus Settings, or IIH Essentials will fail to connect — which is consistent with the issue you’re experiencing if the earlier credentials were incorrect.


I hope this helps

answered
1

Hello Gurumoorthy J,


Your guidance helped me a lot.


Thank you so much :)

answered